2.Create the floppy using dd if=VOL.000.000 of=/dev/rfd0135ds18.
Installing Driver
=================
1.Use custom or scoadmin software to install the driver from the media image or from the floppy created above.
2.After the package is installed, use netconfig to add the new network adapter and configure network protocol and address.
3.Once the adapter is added, modify the hardware configuration in Advanced Options to change line speed and flow control if desired. The different settings of these parameters are listed below:
*Note that 1000 Mbps (1 Gbps) full duplex fixed speed is only valid for fibre connections. For copper twisted pair connections, 1 Gbps can only be set through auto negotiation with a 1 Gbps link partner.
**Note that auto negotiation of flow control is only valid when the line speed is set to auto negotiation (all speeds advertised or single speed advertised).
A kernel rebuild and reboot is required before the new configuration will take effect.