INSTALL.TXT
11OCT94

TCP188.EXE can be installed  from either:
  A. The server where it will run (local installation).
  B. Or from a workstation attached to the server (remote
  installation).  
NOTE: Do NOT just copy the files in.  If you do, existing Novell
products will be damaged.

A. Local Installation of TCP188
-------------------------------
1. Use the DOS Label command to label a floppy disk SNMP_1. 

2. Unzip TCP188.EXE onto that floppy disk.

3. From the server console, type the following command:
        LOAD INSTALL <Enter>

4. At the Install NLM screen, select Product Options.

5. Press <Insert> to add a new product.

6. Insert the diskette with the TCP188 files in the disk drive.  If
the diskette is not in drive A:, change the drive letter to the
correct letter.  Then, press <Enter> to start the installation.

7. When installation is complete, Press <Esc> to get to the Main menu.

8. Press <Esc> to exit the Install NLM.

9. Bring down the server by typing the following commands:
     DOWN
     EXIT

10. Restart the server by typing the command: SERVER

TCP188 is now installed on the server.


B. Installing TCP188.EXE remotely
---------------------------------
1. Log into the server where you are installing TCP188.

2. Create the directory SYS:SNMP_1 on the server by entering the
following commands at your workstation:
     MAP Q:=SYS:
     Q:
     MD SNMP_1
     CD SNMP_1

3. Copy the files and subdirectories from TCP188 into the SYS:SNMP_1
directory.

4. Run RCONSOLE.

5. Load the Install NLM by typing: LOAD INSTALL

6. At the Install NLM screen, select Product Options.

7. Press <Insert> to add a new product.

8. At the prompt, type SYS:SNMP_1 and press <Enter>.

9. When installation is complete, Press <Esc> to get to the Main menu.

10. Press <Esc> to exit the Install NLM.

11. Bring down the server by typing the following commands:
        DOWN
        EXIT

12. Restart the server by typing the command: SERVER

TCP188 is now installed on the server.