SNMP trap data is included with NetWare for SAA v1.3 Rev B so NetWare for SAA
event messages are also displayed in the NetWare Management System (NMS)
alarm monitor and alarm report.  To access this feature, perform the
following tasks:

Note: This procedure is not necessary if you have installed NetWare for SAA
Services Manager v2.0 on your workstation.

- Copy the CE.MIB and NWSAA.MIB files to the NMS\SNMPMIBS\TRAPMIBS directory
on your NMS workstation.  The CE.MIB file is located in the \NMS directory on
the Communication Executive installation diskette DISK5, and the NWSAA.MIB
file is located in the \NMS directory on the NetWare for SAA installation
diskette DISK3.

- From the NMS Tools Menu, access the SNMP Alarm Integrator and integrate the
trap MIBs into the NMS system.

- To enable context-sensitive help from the NMS alarm report, copy the CE.HLP
and NWSAA.HLP files to the NMS\Help directory on your NMS workstation.  The
CE.HLP file is located in the \NMS directory on the Communication Executive
installation diskette DISK5, and the NWSAA.HLP file is located in the \NMS
directory on the NetWare for SAA installation diskette DISK3.

- Add the network address of your NMS workstation to the Protocol IPX section
of the TRAPTARG.CFG file on each server from which you wish the NMS alarm
monitor and alarm report to receive NetWare for SAA event messages.  This file
is located in the \ETC directory of the SYS volume.