~-1
Abnormal program termination
~-2
The SelectWare System was started from an invalid drive.
To start: Log on to your floppy drive, then type SWSTART
~-3
The SelectWare System CD was not found.
Check to make sure that the drive is connected, and its drivers
and access software are loaded.
Then, make sure The SelectWare CD is loaded in the CD-ROM drive.
As a preliminary test, you should be able to list the
directory of The SelectWare System disc.
~-4
Unable to continue due to corrupt memory chain(s).
Reboot before retrying
~-5
Memory deallocation error. Reboot and restart.
~-6
Demo command line error.  Reboot and retry.
~-7
The SelectWare System was improperly started.
Log onto the drive where the SelectWare System
program files are located.
Then, type SWSTART [Enter] to start.
~-8
The SelectWare System has not been installed.
~-9
There was a problem installing The SelectWare System
to drive %c.  Check the drive, then read the installation
storage->hardrun_pth[0]
instructions and restart.
~-10
There was a problem loading font files ...
Check to make sure The SelectWare System was started
properly.
~-11
The version of The SelectWare System on the CD-ROM does
not match this program.
Please change the CD disc and type SWSTART to try again.
~-12
If this error ends in "12-x", check to make sure your CONFIG.SYS file
has the statements
BUFFERS=8 and FILES=10.  (these are minimum values)
Remember to reboot after making changes to CONFIG.SYS