4|Exiting dial modem procedure because an error occurred; error = ^0; category = ^1. 4|Received ENQ. 4|Received NAK. 4|Received ACK. 4|Block ^0 bytes long after packetizing. 4|EOF detected after ^0 total bytes read from file. 4|^0 bytes read from file. 4|Error occured reading file; error = ^0. 4|Error occured opening file; error = ^0. 4|DTR asserted. 4|DTR negated. 4|Exiting wait procedure because an abort request was detected. 4|Exiting wait procedure because an error occurred; error = ^0; category = ^1. 4|Timed out waiting for response. 4|Found "^2" in input stream at buffer position ^0. 4|Scanning ^1 bytes in input buffer starting at position ^0. 4|Waiting for ^2 in input stream within ^0 60ths of a second. 4|Read ^0 bytes from the $P. 4|Input buffer overflow by ^0 bytes. 4|Error occured on read from serial port; error = ^0. 4|Error occured on write to serial port; error = ^0. 4|Error occured on serial port SerStatus call; error = ^0. 4|Timout occured on write while waiting for serial port. 4|Writing ^0 bytes to the $P. 4| ^2 4|The $P driver was successfully opened. 4|^0 error opening the $P input driver. 4|^0 error opening the $P output driver. 4|Closing the $P driver. 4|Opening the $P driver. 1|CRC data resource missing. 1|Transmission failed! 1|Transmission aborted! 1|Aborting transmission. 1|The modem is in use; Press and hold the Option key to force it open. 1|Unable to locate a modem! 1|Transmission successful! 2|Unable to hang up the modem! 2|Hang up successful. 1|Hanging up the modem. 2|Transmission failed! 2|Transmission successful. 1|Transmitting the information using EREG protocol. 2|Login successful. 2|Unable to get login verification. 3|Waiting for login verification. 1|Logging into the server. 1|Connected to the server. 1|Can not connect to server. 1|Connecting to the server. 3|The line is too noisy to transmit. 3|Checking for noise on the line. 3|Connected at $C baud. 2|The modem is unable to detect a dial tone. 2|The modem is unable to detect a carrier. 2|The line is busy. 2|Dial failed! 1|Dialing the modem. 3|Can't initialize the modem on the $P. 2|Modem found on the $P. 3|The $P is busy and was not forced open. 3|Switching to $B baud. 2|Looking for a modem on the $P at $B baud.