Follow these simple steps to configure your Lucent CellPipe
for eMule. This setup assumes you have a PPPOE connection like DSL running. |
|
Start a telnet session with your routers IP. To do so | |
a) Use the Windows Hyper Terminal and type in a Name (does not matter which) for the new session, choose TCP/IP (Winsock) as connection type then enter your router's IP as the host address |
|
or | |
b) Go to Start -> Run -> telnet router's IP | |
In the telent sessions that starts enter these commands each on a single line: | |
pat addpatin pppoe 4662/tcp client's IP pat addpatin pppoe 4672/udp client's IP save |
|
Router's IP is the IP address of your CellPipe router and client's IP is the IP address of your computer running eMule. |
Many thanks to Jarek for this how to.