SP * Save Picture

A tool to extract a picture from the dump file created by WHDload.

Installation

SP is contained only in the DEV archive, not in the USR archive
copy it to C: or a similar place

Usage

First a dump file must be created. Start the program from which the picture is to be ripped. It must run with the option Snoop/S enabled. Also a DebugKey/K/N should be set. If the picture you like to rip appears press the DebugKey. WHDLoad will now write the dump file. Enter the directory using a Shell where the dump file is located. Now invoke SP with filename of the to save as argument. SP will load the dump file and try to save the picture.

Options

OUTPUTFILE/A,cs=copstop/K,height/K,con0/K,mod1/K,mod2/K,pt1/K,pt2/K,pt3/K,pt4/K
OUTPUTFILE/A the filename of the picture to save
cs=copstop/K this options specifies the address to stop interpreting the copperlist. It must be used if the screen is built up of more than one picture
height/K specifies the height of the picture to save
con0/K overwrites the bplcon0 register contained in the dump file
mod1/K,mod2/K overwrites the bplmod1/bplmod2 register contained in the dump file
pt[1-4]/K overwrites the bplpt[1-4] register contained in the dump file