How to remote control the server ?

 

  1. You must first activate remote control in the server config dialog. Click on the check box, change the port number if really need to, choose a password ( highly recommended ). If you have a very slow connection then you can increase the control refresh value. You should however keep this value higher than 3. Do not forget to click on OK.





  2. In order to remote control the server, we must first disconnect the local frontend ! Otherwise the connection will fail.

    You are now supposed to be on the computer from where you want to remote control the server.

    You must install CesarFTP if it is not already the case. After follow the following instructions.

    Here you must fill up the correct address ( IP or hostname, the password you previously set, then click ok.

    You should then be able to read :
    Control connection successfully created

    You should now be able to configure the server.

       



Go to main page

Copyright © 2000, 2001 ACLogic, Alexandre Cesari