ocr: Where to put a PAL/NTSC switch into your Amiga 500: If you have a PAL Amiga, Location of the PAL test these two pads are tied Pad inside the A500 case: togeth- (Rev, 6A+ boards) er, and you need to cut them apart with an Exacto knife. (1) AGNUS CHIP Then solder a wire to the rightmost pad. Connect this wire to Circuit a SPST - - - - - - - - - SPST Switch Board Screw switch, (Or other and connect the other side to a ground. (2) ground point) To - GROUND >>>>> Disclaimer! I take NO responsibility for any of this, but it works for Me. Note: to switch modes, toggle the switch and reset your Amiga.
(.png)
