RESTORE
This command will reset the DATA statement pointer to the very first piece of data in your program. Optionally, if you specify a label, it will reset to the DATA statement immediately following that label. To create a DATA statement label you must write a label in your program followed by a sequence of DATA commands. The label can be made up from any combination of alphabetic characters, but you must end the declaration of the label using a colon(:). You only need to use a colon when you are declaring the label, and a colon should not be used when calling the RESTORE command.

SYNTAX
RESTORE
RESTORE label

RELATED INFO
Basic Commands
Glossary

EXAMPLE
DATA Commands