STAIRS & MANUAL DIMENSIONS

STAIRS
Firstly, before selecting OTHER / STAIRS from the menu bar, change the view to the plan of the floor the base of the stairs are to appear on. Make you selections from the dialogue box - the stairs will also show on the floor above


MANUAL DIMENSIONS
select OTHER / MANUAL DIMENSIONS from the menu bar
Press enter on the two points and input the dimension (if your points are directly on walls the input box will show the dimension )

Manual dimensions can only be horizontal or vertical - your mark points should be approximately horizontal or vertical some door types

the first point is taken as the offset) some door types

NOTE
The text size used is the same as used in rooms - this can be changed permanently in CONFIGURE DIMENSIONS