Resizing Objects



Resizing Components

Resizing a component can be better described as moving one of the component's end points while the other end point stays in the same place.
  1. To resize components, the Editor must be in Selection Mode. Select the Selection Cursor from the Components Toolbar

  2. The mouse cursor will change to the Selection Cursor to indicate that the Editor is in Selection Mode.

  3. Position the mouse cursor over a component's end point and the cursor will change to indicate that the end point can be moved. If the cursor is positioned over an end point that belongs to more than one component, then all of these components will be resized - unless some of these components are selected, in which case only the selected components will be resized.

  4. Click and hold the left mouse button, drag the mouse to move the end point(s), and then release the mouse button.




Resizing Rectangular Circuit Objects

  1. To resize any object, the Editor must be in Selection Mode. Select the Selection Cursor from the Components Toolbar

  2. The mouse cursor will change to the Selection Cursor to indicate that the Editor is in Selection Mode.

  3. Click the left mouse button once on the circuit object to select it. Selected rectangular circuit objects, that can be resized, will acquire drag handles like this:
    A selected Output Signal

  4. Position the mouse cursor over one of the drag handles, and the cursor will change to indicate that the drag handle can be moved.

  5. Click and hold the left mouse button, drag the mouse to move the drag handle, and then release the mouse button.