Genius LT WIN32S Installation Hints

Microsoft WIN32S makes it possible to run a 32-bit application with
the normal Windows 3.1 (a 16-bit application).  Genius LT is a 
32-bit application making WIN32S necessary.

Genius LT is shipped with a WIN32S, but this is only installed 
(automatically) if no existing WIN32S is found.

There are two cases where a WIN32S will not be found:

1) The existing WIN32S is executable but is older than the one delivered
   with Genius LT.  Theoretically, Genius LT should run without having to
   install the delivered WIN32S.  In spite of this, you can still install
   the delivered WIN32S.  However, because this concerns a function with
   system dependencies, there is a small risk that if you do install ours,
   you may bring your Windows installation into a non-executable state
   ("out to lunch -- forever"). Should this occur, refer to the next hints.

2) The existing WIN32S has been entered into a non-executable state.
   This is why its version could not be determined.  Please check the
   following entries in the SYSTEM.INI file in your Windows directory:

   In the [boot] section, there should be a "drivers" entry containing at
   least a "mmsystem.dll" and a "winmm16.dll" modifier.

   [boot]
   ...
   drivers=mmsystem.dll winmm16.dll

   In the [386enh] section, there needs to be a "device" entry where
   the W32S.386 file can be found.  There can only be one entry for
   the file W32S.386!   

   [386enh]
   device=c:\windows\system\win32s\w32s.386

   You have to activate SHARE.EXE before you start WIN32S.

   In addition to this, you have to set up virtual memory.  This can
   be performed from the "control panel" (typically found in the "Main"
   group).  There, you need the do the option "386 enhanced".

   The conditions named above are the minimal requirements.  On your
   computer, there could be other dependencies playing a role.

   If you would like to install the WIN32S that was delivered, start
   the Genius LT "setup" program and select "(Install Microsoft WIN32S)".

   If you explicitedly install the delivered WIN32S over the existing
   WIN32S, the install program will copy all files that it will overwrite
   or change into a directory called WIN32S.OLD in the Genius LT main
   directory.