Installing the WLBS Network Monitor Parsers

Copy the Wlbs_hb.dll and Wlbs_rc.dll files to your Netmon\Parsers directory.
Open the Mac.ini file in the Netmon\Parsers directory.

In the [ETYPES] section, add the line "0xBF01 = WLBS_HB" and "0x886F = WLBS_HB", so that the section looks similar to this:

	[ETYPES]
	0x600   =   XNS
	0x800   =   IP
	0x806   =   ARP_RARP,1
	0x0bad  =   VINES_IP
	0x1984  =   TRAIL
	0x8035  =   ARP_RARP,2
	0x809B  =   LAP
	0x80D5  =   SNA
	0x80F3  =   AARP
	0x8137  =   IPX
	0x8138  =   IPX
	0x86DD  =   IP6
	0xBF01  =   WLBS_HB
	0x886F  =   WLBS_HB

Open the Tcpip.ini file in the Netmon\Parsers directory.

In the [UDP_HandoffSet] section, add the line "1717 = WLBS_RC" and "2504 = WLBS_RC", so that the section looks similar to this:

	[UDP_HandoffSet]
	53   = DNS
   	67   = DHCP
   	68   = DHCP
   	111  = RPC
   	161  = SNMP
   	162  = SNMP
   	137  = NBT, 1000
   	138  = NBT, 1002
   	139  = NBT, 1001
   	520  = RIP
   	1717 = WLBS_RC
   	2049 = RPC
   	2504 = WLBS_RC

Open the Parser.ini file in the Netmon directory.

In the [PARSERS] section, add the lines "WLBS_RC.DLL = 0: WLBS_RC" and "WLBS_RC.DLL = 0: WLBS_RC", so that the section looks similar to this:

	[PARSERS]
<Other Parsers>
	    LDAP.DLL    = 0: LDAP
	    TDS.DLL     = 0: TDS
	    ATMARP.DLL  = 0: ATMARP
	    RSVP.DLL    = 0: RSVP
	    UNI31.DLL   = 0: UNI31
	    RTPPARSR.DLL= 0: RTP, RTCP
	    TCPIP6.DLL  = 0: IP6, ICMP6
	    CLSC.DLL    = 0: CLSC
	    L2TP.dll	= 0: L2TP
	    WLBS_HB.DLL = 0: WLBS_HB
	    WLBS_RC.DLL = 0: WLBS_RC

At the bottom of the Parser.ini file, add the following information exactly as listed below:

	[WLBS_HB]
	Comment     = "WLBS Heartbeat"
	FollowSet   = 
	HelpFile    =

	[WLBS_RC]
	Comment     = "WLBS Remote Control Protocol"
	FollowSet   = 
	HelpFile    =

Save the .ini files.