Number 165
December 23, 1986

Title:  Hayes 2400 Baud Modems

It has been found that some Hayes 2400 baud modems are not configured
correctly to work with NetWare V2.0 and above ASYNC Bridges.  The same
Bridge, however, will work with a Hayes 1200 baud modem.  The error
displayed on the screen by the 2400 baud modem response program reads "The
modem (if it exists) is not esponding to initialization efforts."    On the
2400 baud modem, check to see if the firmware is set to the factory
settings.  To do this, you should run the communication package of your
choice. While in terminal mode, type the following:

       AT&F&W

The modem will then respond with an "OK."  This will indicate that your
modem is now set to the factory settings.  In most cases, resetting the
modem as done above corrects the problem.