External dialer setup

IP Address: Fixed: You can use enviroment variable name (eg. %MYIP%) Read message from file PPP.LOG (eg. with EtherPPP) Use only WATTCP configuration file (eg. with Klos PPP) Try to do BOOTP (works with SLIPPER, CSLIPPER, DOSPPPD)	Name of WatTcp configuration file: TCP/IP settings (optional) 1st nameserver 2nd nameserver (optional) Note: following values will be ignored, when IP Address is set to BOOTP or when Arachne uses WATTCP configuration file. 1st gateway 2nd gateway (optional) Netmask
Packet driver command: (eg: @cslipper com3 baud=19200 vec=60 irq=4) Packet driver unload command: (try @termin.com 0x60>NUL) Automatic dialer command: (eg: @miniterm.exe>PPP.LOG) Terminal window for manual dialing: (eg. @comtool.com 3) These commands MUST begin with @. URL to display as "dialing page": (try file:dialinit.htm) The file: protocol must be specified in URL. The arachne:dialer, arachne:hangup and arachne:exit URL's can be included as links in this page.

Basic communication setup: COM1 COM2 COM3 COM4 IRQ 3 (COM2,COM4) IRQ 4 (COM1,COM3) IRQ 5 (sometimes COM3,COM4) IRQ 7 (almost unused) < 9600 bps < 19200 bps < 38400 bps < 115200 bps Advanced communication setup: special base address: (0x???) use default base address for selected COM port (1...0x3f8, 2...0x2f8, 3...0x3e8, 4...0x2e8) Data transfer mode: (databits/parity/stopbits) Modem init string: (try ATZ,AT&F,AT&F0...) Dialing method: Tone dial (ATDT) Pulse dial (ATDP) Czech Telecom (ATX3DP)

Phone number: Terminal window: Show terminal window Autologin: Try following dialogue Wait for: Reponse: Wait for: Reponse: Wait for: Reponse: Wait for: Reponse: Wait for: Reponse: Wait for: Reponse: