MKMSGF
IDRIVERNAMEIPRIMARYIALTERNATEIRECVBUFSIRECVBUFSIZEIXMITBUFSIXMITBUFSIZEIRAMIPRODUCTIDINETADDRESSIMAXTRANSMITSIEARLYRELEASEIADAPTERIENABLEBRIDGEIBRIDGERAM?
IIBM Token-Ring Network Driver, Version %1
EA failure during initialization of the IBMTOK.OS2 device
driver has occurred.
IAn unrecognized parameter %1 was found in PROTOCOL.INI.
EA value specified for a parameter in PROTOCOL.INI is not valid.
EA configuration error was found in PROTOCOL.INI.
EThe adapter is not responding or was not found.
EThe protocol manager could not be opened.
EA lobe wire fault has been detected.  The adapter will be closed.
EThere are not adequate receive buffers for the adapter to open.
IIBM Token-Ring adapter data rate is %1.
EAn invalid node address error occurred when the program attempted to open the adapter.
EThe receive buffer length defined is not valid.  The adapter was not opened.
EThe adapter transmit buffer length defined is not valid.  The adapter was not opened.
EA maximum of two Token-Ring Shared Ram device drivers may be active at the same time.
EA new Token-Ring adapter cannot be opened in autosense mode if it is the only station on the ring.
EAn unexpected error caused the Open Adapter Command in the IBMTOK.OS2 device driver to fail.  The open return code is %1.
EAn auto-removal error has been detected.  The adapter will be closed.
EA remove MAC frame has been received.  The adapter will be closed.
EA failure during initialization of the IBMTOK.DOS driver has occurred.
         Press any key to continue......
EAn open error occurred during the lobe media test phase.
EAn open error occurred during the physical insertion phase.
EAn open error occurred during the address verification phase.
EAn open error occurred during the roll call poll phase.
EAn open error occurred during the request parameter phase.
EThe open error type is Function failure.
EThe open error type is Signal loss.
EThe open error type is Frequency Error.
EThe open error type is Timeout.
EThe open error type is Ring failure.
EThe open error type is Ring beaconing.
EThe open error type is Duplicate node address.
EThe open error type is Parameter request.
EThe open error type is REMOVE received.
EThe open error type is no monitor present or no signal detected.
EThe open error type is Monitor contention failed for RPL.
EFor this micro-code level, the value specified for XMITBUFS in the file PROTOCOL.INI must be greater than 1.  Run-time errors may occur if this value is not increased.  IBMTOK.OS2 has defaulted this value to 2. See the help for this message for 
further corrective action.