In this Appendix a list of the commands for the Kermit-32 implementation is presented.
@ |
synonym for ``take'' |
BYE | to remote server |
CONNECT | as terminal to remote system |
EXIT | from Kermit-32 |
FINISH | Shut down remote server |
GET | remote files from server |
HELP | with Kermit-32 |
LOCAL | prefix for local file management commands |
LOG | remote terminal session |
LOGOUT | remote server |
PUSH | to DCL command level |
QUIT | from Kermit-32 |
RECEIVE | files from remote Kermit |
REMOTE | prefix for remote file management commands |
SEND | files to remote Kermit |
SERVER | mode of remote operation |
SET | various parameters |
SHOW | various parameters |
STATISTICS | about most recent file transfer |
TAKE | Kermit-32 commands from a file |
In particular, the possible options for the SET command are the
following:
BLOCK/SMALL>_CHECK | Packet transmission error detection method |
DEBUGGING | Record or display state transitions or packets |
DELAY | How long to wait before starting to send |
ESCAPE | Character for terminal connection |
FILE | For setting file parameters like file type |
HANDSHAKE | For establishing half duplex line turnaround handshake |
IBM/SMALL>_MODE | For communicating with an IBM mainframe |
INCOMPLETE/SMALL>_FILE | What to do with an incomplete file |
LINE | Terminal line to use for file transfer or CONNECT |
LOCAL/SMALL>_ECHO | For terminal connection, ON or OFF |
MESSAGE | The type of typeout to be done during transfers |
PARITY | Character parity to use |
PROMPT | Change the program's command prompt |
RECEIVE | Various parameters for receiving files |
REPEAT/SMALL>_QUOTE | Character to use for repeat compression |
RETRY | How many times to retry a packet before giving up |
SEND | Various parameters for sending files |