SVM.EXE
SVM is a menu driven program designed to select and test all video modes available to the adapter.
How to use SVM

The SVM program can be executed in one of two ways: by calling up the menu and selecting from the menu choices, or by entering the desired mode directly with a specific command line.
How to use SVM from The Menu

Go to the SPEA directory where the utilities are installed and call the program with the following call:
    SVM


The top bar shows the available color depths. This is traversed through by the use of right/left arrow keys.


The program provides all the different resolutions supported by the chip under each color depth. These resolutions are traversed by the up/down keys. 

The graphics adapter can be tested for each resolution/mode by first highlighting the section, then pressing the F5 key.
The graphics adapter can be run at a selected mode by first selecting the mode and then pressing ENTER.


How to use SVM from the Command Line

The SVM program may be used to select a mode directly from the command line following two simple steps:
Go to the SPEA directory where the utilities are installed.

1. Enter the following command:

SVM mode number
mode number is the corresponding hex mode visible when you start the program menu driven.