\GH
Syntax: GH [<address>]
Use: Set hardware and code breakpoints and execute the program.
Example: 'GH' executes the program with hardware breakpoints enabled.
\HA
Syntax: HA [?] [*] [+] [-]
Use: HA ? displays, * clears, + enables, and - disables all hardware break-
points.
Example: 'HA ?' displays all hardware breakpoints.
\HB
Syntax: HB [<datatype> xxxx xxxx] [?] [*] [+] [-]
Use: Set hardware data bit breakpoints.
Example: 'HB LB 1000 xxx0' sets a data breakpoint for even values from 80H
to 8EH as a low byte.
\HC
Syntax: HC [#<number>] [B-|B+] [C-|C+] [O-|O+] [P-|P+] [S-|S+] [TB|TC|TT]
[X<byte>] [?] [*]
Use: Set hardware controls, including the pass counter, buffer capture,
cycle count capture, overflow stop, probe cycle display, selective trace,
trigger location, and excluded states.
Example: 'HC * #10 S+' clears the controls and sets the pass counter to 10H
and turns selective trace on.
\HD
Syntax: HD [<datatype> <byte|number|address>] [?] [*] [+] [-]
Use: Set hardware data breakpoints.
Example: 'HD LW 1234' allows breakpoints when the low word is 1234H.
\HM
Syntax: HM [<address><address> A|H|R|W|X [B][(s,t)]] [?] [*] [+] [-]
Use: Set a hardware breakpoint when a range of memory is accessed via int-
errupt acknowledge, halt, read, write, or code prefetch.
Example: 'HM 0:0 0:F W' sets a breakpoint on memory writes from 0:0 to 0:F.
\HP
Syntax: HP [<port> [<port>] I|O [B][(s,t)]] [?] [*] [+] [-]
Use: Set a hardware breakpoint when a range of I/O ports is read or written.
Example: 'HP 308 309 I' sets a breakpoint on reads of port 308 or 309H.
\HR
Syntax: HR [$] [![#<number>]] [<segment>] [<file>] or HR [*]
Use: Display the hardware trace buffer in raw format.
Example: 'HR' displays the last page of the trace buffer.
\HS
Syntax: HS [<segment>] or HS [*]
Use: Display the last entry of the hardware trace buffer in raw format.
Example: 'HS' displays the last entry in the trace buffer.
\HT
Syntax: HT [$] [![#<number>]] [<segment>] [<file>] or HT [*]
Use: Display the hardware trace buffer in mixed data/disassembly format.
Example: 'HT' displays the last page of the trace buffer.
\HU
Syntax: HU [$] [![#<number>]] [<segment>] [<file>] or HU [*]
Use: Display the hardware trace buffer in disassembly-only format.
Example: 'HU' displays the last page of the trace buffer.
\HW
Syntax: HW <file> or HW A: or HW B:
Use: Save the hardware trace buffer to a disk file or to a floppy disk.
Example: 'HW PSBUF.DAT' saves the trace buffer to disk for later use.
\