You have: meters
You want: feet
* 3.2808399
/ 0.3048
You have: cm^3
You want: gallons
* 0.00026417205
/ 3785.4118
Powers of units can be specified using the '^' character as shown in
the example, or by simple concatenation: 'cm3' is equivalent to 'cm^3'.
Multiplication of units can be specified by using spaces, a dash or
an asterisk. Division of units is indicated by the slash ('/').
Note that multiplication has a higher precedence than division, so
If the user enters incompatible unit types, the units program will
print a message indicating that the units are not conformable and
it will display the reduced form for each unit:
You have: ergs/hour
You want: fathoms kg^2 / day
conformability error
2.7777778e-11 kg m^2 / sec^3
2.1166667e-05 kg^2 m / sec
The conversion information is read from a units data file. The default file includes definitions for most familiar units, abbreviations and metric prefixes. Some constants of nature included are:
pi ratio of circumference to diameter c speed of light e charge on an electron g acceleration of gravity force same as g mole Avogadro's number water pressure per unit height of water mercury pressure per unit height of mercury au astronomical unit'Pound' is a unit of mass. Compound names are run together so 'poundforce' is a unit of force. British units that differ from their US counterparts are prefixed with 'br', and currency is prefixed with its country name: 'belgiumfranc', 'britainpound'. When searching for a unit, if the specified string does not appear exactly as a unit name, then the units program will try to remove a trailing 's' or a trailing 'es' and check again for a match.
All of these definitions can be read in the standard units file, or you can supply your own file. A unit is specified on a single line by giving its name and an equivalence. One should be careful to define new units in terms of old ones so that a reduction leads to the primitive units which are marked with '!' characters. The units program will not detect infinite loops that could be caused by careless unit definitions.
Prefixes are defined in the same was as standard units, but with a trailing dash at the end of the prefix name.
The effect of including a '/' in a prefix is surprising.
Exponents entered by the user can be only one digit.
The user must use | to indicate division of numbers and / to indicate division of symbols. This distinction should not be necessary.
The program contains various arbitrary limits on the length of the units converted and on the length of the data file.
You can type `quit' to quit the program.